T-1000 961-075-000

# Product Introduction
The T1000 converter is an electro-pneumatic conversion device that converts analog electrical signals into proportionally output pneumatic pressure signals. Its inlet pressure ranges from 1.27 Bar to 7 Bar. The analog electrical signals can be mA current signals or 0–1 VDC voltage signals.


Feature 1: Equipped with a pneumatic flow amplifier in its design, this product achieves a flow rate of up to 12 SCFM (20.16 m³/hr). The allowable inlet pressure ranges from the minimum required output pressure plus 0.21 Bar to a maximum of 7 Bar.


# Product Specifications
Type 1000 Series Electro-Pneumatic Converter
## Features
- Adopts a pneumatic flow amplifier in design, delivering a flow rate up to 20.16 m³/hr
- Allowable inlet pressure range: minimum required output pressure plus 0.21 Bar up to a maximum of 7 Bar
- Convenient external zero adjustment and calibration
- Compact structure with small dimensions and light weight
- Slightly affected by fluctuations in inlet pressure
- Mountable at any angle
- Capable of reverse control
- Low air consumption


## Description
### Extended T1000 Series
The extended T1000 series delivers a flow rate of up to 40.32 m³/hr at an output pressure of 10.19 Bar. This model features a wide adjustment range, supporting output pressures from approximately 0.212–46 Bar to 0.21–10.19 Bar. The maximum allowable supply inlet pressure is 10.4 BAR, with an air flow capacity of 38 m³/hr. T1000 I/P and E/P converters boast far higher efficiency than ordinary converters paired with amplifiers and pilot valves.


### Fast Exhaust T1000
Drawing on the proven precision, reliability and structural design of the standard T1000, we developed the fast-exhaust T1000 converter. This unit rapidly exhausts backpressure without residual backpressure buildup. Its fast exhaust characteristic makes it ideal for rapid cylinder retraction, pneumatic lifting, and other applications requiring fast gas discharge. The maximum inlet pressure is 7 BAR, output pressure ranges from 0.07 BAR–1.2 BAR to 0.42–2.11 BAR, and exhaust flow reaches 11.76 m³/hr.


### Partial Pressure Range Adjustment for Applications
The model with 4–20 mA input and 0.21–0.63 BAR output can be reconfigured to deliver partial pressure outputs of either 0.21–0.63 BAR or 0.63–1.05 BAR.


### Mounting
The T1000 converter can be installed anywhere via pipe connection, panel mounting or bracket mounting. Zero recalibration is required if mounted at a non-vertical angle. For maximum output pressure stability, the T1500 must be mounted vertically with no vibration, or vibration isolation must be implemented along the X and Z axes.


### Reverse Control
All T1000 converters are factory preset for forward control. Reverse control requires signal inversion and simultaneous calibration of the positive and negative poles of the lead wires.