DWCT
Specifications detailed
contents of a project
Order product No. LS-401-C2
Model number, LS-401-C2
Operating status indicator orange LED (lit on output 1,2 ON)
Laser projection indicator green LED (light during laser illumination)
Environmental resistance: -10~ + 55℃ (4~7 close to installation: -10~ + 50℃, 8~16 close to installation: -10~ + 45℃)
(Be careful not to expose or ice.)
Storage time: -20~ + 70℃
Environmental resistance: use the ambient humidity: 35~85%RH, and the storage time is: 35~85%RH
Environmental resistance: voltage resistance AC1,000V 1 minute between all power connection terminals and housing
Environmental resistance: insulation resistance between all power supply connection terminals and housing, above 20M, DC250V-based high resistance meter
Environmental resistance: vibration resistance frequency of 10~150Hz double amplitude of 0.75mm X, Y and Z direction for 2 hours each
Environmental resistance: impact resistance acceleration 98 m/s2 (about 10G) X, Y and Z direction 5 times each
Material body shell: heat-resistant ABS
Cover: polycarbonate
Button button switch: propylene
Highlight switch: ABS
Cable 0.15mm2 5-core rubber cable, 2m long
Weight Body weight: about 65g
Packaging weight: about 75g
Power supply voltage 12~24V DC ± 10% pulse P-P below 10%
Consumption current usually working: below 950mW (when supply voltage 24V, consumption current below 40mA)
In ECO mode: below 780mW (supply voltage at 24V, consumption current below 33mA)
Output (output 1, output 2), NPN open circuit collector transistor
* Large inflow current: 100mA (Note)
· External voltage: below 30V DC (between output and 0V)
Remaining voltage: below 1.5V [inflow current is 100mA (Note)]
(Note): 50mA for 5 to 8 series connections and 25mA for 9 to 16 series connections.
Output (output 1, output 2): the output action can be selected by the highlight switch to enter the light ON / short ON
Output (output 1, output 2): short-circuit protection equipment
The reaction time is under 80s (H-SP), 150s (FAST), 500s (STD), and 4ms (U-LG)
External input (light drop stop fully automatic instruction / limited instruction) NPN without contact input
Signal condition: High... + 5V~ + V or disconnected, Low... 0~ + 2V (source current below 0.5mA)
Input impedance: about 10 kΩ
Select indicator yellow LED (lit on selecting output 1,2)
MODE indicator lamp RUN: green LED
TEACH · L / D · TIMER · CUST · PRO: Yellow LED
Numbers display a 4 bit (green) + 4 bit (red) LED display
Sensitivity setting method usual mode: 2 instruction / limit instruction / fully automatic instruction / manual adjustment
Window comparison mode: teaching (1,2,3) / manual adjustment
Tolerance mode: instruction (1,2,3) / manual adjustment
Differential mode: Set for 5 steps
Set the sensitivity fine-tuning function is equipped
The timer function is equipped with a variable on delay timer / off delay timer / ONE SHOT timer valid / invalid switching type
Timer function: the timer time is about 1~9,999ms
Automatic anti-interference function equipment [* Most can be installed close to 4 test heads (invalid in H-SP mode)]
The total length of the cable extending over 0.3mm2 can be extended to 100m
